UEN00099-00 10 Structure, function and maintenance standard 2. PC valve PA : Pump port PA2 : Pump pressure pilot port PDP : Drain port PM : Mode selector pressure pilot port PPL : Control pressure output port (to LS valve) 1. Plug 2. Servo piston assembly 3. Pin 4. Spool 5. Retainer 6. Sheet 7. Cover 8. Wiring Function q When the pump discharge pressure (PP1) (self-pressure) and (PP2) (other pump pres- sure) are high, the PC valve controls the pump so that the volume of oil beyond the discharge pressure-based specific flowrate may not be conducted however you may increase the con- trol valve stroke.
Namely it is intended at con- trolling the horse power for the pumps so that it may not exceed the engine hose power. q If the engine speed goes below the specified value because of increased load, the controller sends a command current to PC-EPC valve solenoid in order to reduce the slope angle in proportion to reduction in the engine speed. q If the pump discharge pressure increases due to increased load during operation, this valve decreases the pump delivery. q And if the pump delivery pressure goes low, it increases the pump delivery.
q In this case, relation between the mean dis- charge pressure of the front and rear pumps [(PP1) + (PP2)]/2 and the pump delivery (Q) will becomes as shown in the diagram if the relation is represented as the parameter the current value (X) to be given to PC-EPC valve solenoid. q The controller continues counting the actual engine speed. q If the engine speed is slowed down due to increased load, the controller reduces the pump delivery to recover the speed. 18 PC210, 230, 240-8