UEN00160-00 10 Structure, function and maintenance standard Function q This valve reduces the swing back generation in the swing body by the inertia of the swing body, the backlash and rigidity of the machin- ery system, and the compression of the hydraulic oil when the swing is stopped. 2. When motor is stopped temporarily q The motor rotation is reversed by the closing pressure generated at port (MB). (1st time: reverse rotation) q Reversing pressure is generated on port (MA). Pressure (MA) is conducted to chamber (a).
q The valve contributes in preventing collapsing of load when the swing is stopped and also contributes in reducing cycle time (enhances the positioning performance, enabling you to proceed to the next work quicker than ever). q The pressure compresses spring (3) by use of the difference in areas of circles ( φ D3 > φ D4) of spool (2) and moves spool (2) to the right side. q Port (MA) o chamber (b) will be intercon- nected. q Ports (b) and (f) will be interconnected through the drilled hole (h) on spool (5). This intercon- nection bypasses the reversing pressure on port (MA) to port (T), thereby preventing the reverse rotation of the 2nd time. Operation 1.
When port (MB) brake pressure is generated q Pressure (MB) is conducted to chamber (d) via notch (g). q The pressure compresses spring (6) by use of the difference in areas of circles ( φ D1 > φ D2) of spool (5) and moves spool (5) to the left side. q Port (MB) o chamber (e) will be intercon- nected. q Since pressure (MA) is lower than the set pres- sure of spring (3), spool (2) does not move and the pressurized oil is kept in. Thus the braking force is ensured. 10 PC210, 230, 240-8