10 Structure, function and maintenance standard UEN00160-00 3) During fine control (When control lever is returned) q Therefore, the pilot pressure oil from the self pressure reducing valve passes through fine control hole (f) and flows to chamber (A) from port (P1) to push the control valve spool. q When lever (5) starts to be returned, spool (1) is pushed up by the force of centering spring (3) and pressure at port (P1). q Because of this, fine control hole (f) is con- nected to drain chamber (D), and the pressur- ized oil at port (P1) is released. q The oil returning from chamber (B) passes from port (P2) through fine control hole (f') and flows to drain chamber (D).
q If the pressure of port (P1) is lowered exces- sively, spool (1) is pushed down by metering spring (2). q Fine control hole (f) is shut off from drain cham- ber (D), and it is almost simultaneously inter- connected to pump pressure chamber (PP). q Pump pressure is supplied until the pressure at port (P1) recovers to the level equivalent to the lever position. q When the spool of the control valve returns, the oil in drain chamber (D) flows in from fine control hole (f') in the valve on the side that is not working. The oil passes through port (P2) and enters chamber (B) to replenish the cham- ber with pressurized oil. 2. Travel signal/Steering function Travel signal q If either of the L.H.
or R.H. travel levers is oper- ated, the higher PPC output pressure of both sides is output as the travel signal. q Accordingly, whether the machine is travelling is judged by the signal of port (P5). Steering signal q If the operation quantities of both levers are dif- ferent from each other as in the steering opera- tion, the higher one of the PPC output pressures of both sides is output as the steer- ing signal. 4) At full stroke q Lever (5) pushes down piston (4), and retainer (9) pushes down spool (1). q Any signal is not output from port (P6) while the machine is travelling straight (forward or reverse) or in neutral.
q Fine control hole (f) is shut off from drain chamber (D), and is interconnected to pump pressure chamber (PP). q Accordingly, whether the machine is being steered is judged by the signal of port (P6). PC210, 230, 240-8 35