UEN00103-00 10 Structure, function and maintenance standard 2) Oil pressure sensor 1. Sensor 2. Connector Function q The junction block has 6 PPC oil pressure sen- sor. q This sensor detects the operating condition of each actuator by the PPC pressure and trans- mit it to the pump controller. Operation q The oil pressure is applied to the diaphragm of the oil pressure sensor from the pressure intake part, the diaphragm is deformed. q The amplifier magnifies output voltage (E) and transmits it to the pump controller. q The deformation in the diaphragm causes the resistance of the gauge to change.
This causes a change in the output voltage, which is transmitted to the amplifier (voltage ampli- fier). q The relationship between the pressure applied to sensors (P) and output voltage (E) is shown in the figure below. 28 PC210, 230, 240-8