Komatsu PC210-8, PC210LC-8, PC210NLC-8, PC230NHD-8, PC240LC-8, PC240NLC-8 — Monitor system

UEN00103-00 10 Structure, function and maintenance standard Working mode selector switch Pressing working mode selector switch (5) switches among working modes. Check the working mode on the working mode monitor. Travel speed selector switch Each time you press the travel speed selector switch, the travel speed setting switches as shown below. Lo o Mi o Hi o Lo …. The travel speed setting is confirmable on the travel speed monitor. The relationship between the speed setting and the monitor display is shown in the table below.

Crawler symbol + Lo Low speed (default) Display Setting Crawler symbol + Mi Medium speed Crawler symbol + Hi High speed Window washer switch While the switch is being pressed, window washer liquid is sprayed out. There is a time delay before the wiper starts. q When you try specifying B mode as a working mode, the buzzer sounds for safety's sake and the following confirmation message appears. About B mode Wiper switch Each time you press the wiper switch, the wiper settings switch as follows. OFF o INT o ON o OFF o The wiper operation setting is confirmable on the wiper monitor. The relationship between the wiper setting and the monitor display is shown in the table below. F5 :

Returns to the working mode selector screen. F6 : Specifies the breaker mode. q If B mode is specified as a working mode when you start the monitor, the buzzer sounds and the following message appears. Air conditioner control switch To operate the air conditioner, use the air condi- tioner control switches. F5 : Starts up in E mode. F6 : Starts up in B mode. 42 PC210, 230, 240-8 Display Setting Wiper actuation status None OFF Stowing stopped or now stowing Wiper symbol + INT INT Intermittent actuation Wiper symbol + ON ON Continuous actuation