Komatsu PC210-8, PC210LC-8, PC210NLC-8, PC230NHD-8, PC240LC-8, PC240NLC-8 — Measuring solenoid valve output pressure

UEN00228-00 30 Testing and adjusting Measuring solenoid valve output pressure 1 a When measuring with hoses (2) – (6), remove the undercover of the control valve. a Measuring tools for solenoid valve output pres- sure k Stop the machine on a level ground and lower the work equipment to the ground. Then, release the residual pressure from the hydraulic circuit. For details, see “Releasing residual pressure from hydrau- lic circuit”. a Before measuring the solenoid valve output pressure, check that the basic pressure of the control circuit is normal. a Measure the solenoid valve output pressure under the following condition. 2. Install adapter N2 and connect the discon- nected hose again. 3.

Install nipple [1] of hydraulic tester N1 and con- nect it to oil pressure gauge [2]. a Use the oil pressure gauge of 5.9 MPa {60 kg/cm 2 }. a The figure shows the measuring tools con- nected to outlet hose (1) of the PPC lock solenoid valve. q Hydraulic oil temperature: Within operating range 1. Disconnect outlet hoses (1) – (6) of the sole- noid valves to be measured. a When measuring with hose (1), remove the undercover (rear side) of the opera- tor's cab. 4. Start the engine. 5. Run the engine at high idle, operate the control levers and switches to turn the solenoid valve ON or OFF, and measure the oil pressure.

a For the conditions for turning the solenoid valve ON and OFF, see the operation table of each solenoid valve. a The operating condition of the solenoid valve can be checked with the monitoring function of the machine monitor (For details, see “Special functions of machine monitor”). q Monitoring code: 02300 Solenoid 1 q Monitoring code: 02301 Solenoid 2 42 PC210, 230, 240-8 Symbol Part No. Part name N 1 799-101-5002 Hydraulic tester 790-261-1204 Digital hydraulic tester 2 799-401-3100 Adapter (Size 02) No.

Solenoid valve to be measured 1 PPC lock solenoid valve 2 2-stage relief solenoid valve 3 Swing holding brake solenoid valve 4 Travel speed shifting solenoid valve 5 Travel junction solenoid valve 6 ATT return selector solenoid valve (Attachment installation specification)