UEN00228-00 30 Testing and adjusting Operation table of PPC lock solenoid valve Operation table of 2-stage relief solenoid valve Operation table of swing holding brake solenoid valve Operation table of travel speed shifting solenoid valve Operation table of travel junction solenoid valve Operation table of ATT return selector solenoid valve (Attachment installation specification) 44 PC210, 230, 240-8 Operating condition Operation Lock lever Lock OFF Free ON Operating condition Operation Overheat 1st setting is ON OFF Overheat 2nd setting is ON All of work equipment, swing, and travel signals are OFF Swing lock switch is ON ON Travel signal is ON L mode is selected Boom LOWER signal is ON P/E mode is selected Left knob switch is ON Signals other than swing single signal are ON Swing single signal is ON OFF Other than above condition Operating condition Operation Work equipment, swing, and travel signals All are OFF OFF Any one is ON ON Operating condition Operation Overheat 2nd setting is ON OFF Fuel control dial is at 1,500 rpm or below Travel speed switch is at Lo/Mi (PC210/230-8) Travel speed switch is at Lo (PC240-8) Travel speed switch is at Hi (PC210/230-8) Travel speed switch is at Mi/Hi (PC240-8) Travel signal is OFF Travel signal is ON F or R pump pressure is 24.5 MPa {250 kg/ cm2} F or R pump pressure is 15.3 MPa {150 kg/ cm2} ON Other than above condition Operating condition Operation Travel steering signal is ON ON Travel steering signal is OFF Travel lever is operated singly F or R pump pressure is 24.5 MPa {250 kg/cm2} or higher Other than above condition OFF Operating condition Operation Working mode:
Other than B OFF Working mode: B ON