Komatsu PC210-8, PC210LC-8, PC210NLC-8, PC230NHD-8, PC240LC-8, PC240NLC-8 — Warning

UEN00230-00 30 Testing and adjusting Check sheet (PC210/LC/NLC-8/PC230NHD-8) 1. Engine 2. Work equipment speed 12 PC210, 230, 240-8 Model Serial No. Service meter User's name Date of execution Inspector / / No. Check item Checking condition Unit Standard value for new machine Service limit value Mea- sured value Good Bad Fuel control dial Work- ing mode Auto- decel- eration Left knob switch Operation of work equipment 1 Engine speed MAX P OFF OFF All levers in neutral rpm 1,990 – 2,130 1,990 – 2,130 2 Engine oil pressure MPa {kg/cm2} Min. 0.29 {Min. 3.0} 0.25 {2.5} 3 Engine speed MIN All levers in neutral rpm 1,000 – 1,100 1,000 – 1,100 4 Engine oil pressure MPa {kg/cm2} Min. 0.10 {Min.

1.0} 0.07 {0.7} 5 Engine speed MAX ON Arm IN relief rpm 1,850 – 2,050 1,850 – 2,050 6 Blow-by pressure kPa {mmHO} 2 Max. 0.98 {Max. 100} 1.96 {200} 7 Engine oil pressure ON OFF All levers in neutral rpm 1,300 – 1,500 1,300 – 1,500 No. Check item Checking condition Unit Standard value for new machine Service limit value Mea- sured value Good Bad Fuel control dial Work- ing mode Checking posture, etc. 1 Boom RAISE MAX P Work equipment extended fully sec 2.9 – 3.7 Max. 4.7 2 Arm IN Boom top horizontal sec 3.1 – 3.9 Max. 4.5 E sec 3.2 – 4.0 Max. 4.6 L sec 6.0 – 7.4 Max. 7.7 3 Arm OUT P sec 2.4 – 3.0 Max. 3.5 4 Bucket CURL Boom top horizontal Arm cylinder retracted fully sec 2.3 – 2.9 Max.

3.3 5 Swing (5 turns) Work equipment extended fully Swing right and left sec 21.7 – 26.7 Max. 30 6 Travel (5 idle turns) One side of track pushed up and turned forward and backward LO STD sec 46.2 – 56.4 46.2 – 60.4 LC/NLC 50.3 – 61.5 50.3 – 65.5 NHD 55.7 – 68.1 55.7 – 72.5 MI STD sec 33.7 – 41.3 33.7 – 45.3 LC/NLC 36.7 – 44.9 36.7 – 48.9 NHD 40.1 – 49.1 40.1 – 53.6 HI STD sec 25.2 – 27.8 25.2 – 29.8 LC/NLC 27.3 – 30.3 27.3 – 32.3 NHD 26.7 – 29.7 26.7 – 31.6