Komatsu PC210-8, PC210LC-8, PC210NLC-8, PC230NHD-8, PC240LC-8, PC240NLC-8 — Pm Clinic service

UEN00230-00 30 Testing and adjusting Check sheet (PC240LC/NLC-8) 1. Engine 2. Work equipment speed 18 PC210, 230, 240-8 Model Serial No. Service meter User's name Date of execution Inspector / / No. Check item Checking condition Unit Standard value for new machine Service limit value Mea- sured value Good Bad Fuel control dial Work- ing mode Auto- decel- eration Left knob switch Operation of work equipment 1 Engine speed MAX P OFF OFF All levers in neutral rpm 2,090 – 2,230 2,090 – 2,230 2 Engine oil pressure MPa {kg/cm2} Min. 0.29 {Min. 3.0} 0.25 {2.5} 3 Engine speed MIN All levers in neutral rpm 1,000 – 1,100 1,000 – 1,100 4 Engine oil pressure MPa {kg/cm2} Min. 0.10 {Min.

1.0} 0.07 {0.7} 5 Engine speed MAX ON Arm IN relief rpm 1,850 – 2,050 1,850 – 2,050 6 Blow-by pressure kPa {mmH2O} Max. 0.98 {Max. 100} 1.96 {200} 7 Engine oil pressure ON OFF All levers in neutral rpm 1,300 – 1,500 1,300 – 1,500 No. Check item Checking condition Unit Standard value for new machine Service limit value Mea- sured value Good Bad Fuel control dial Work- ing mode Checking posture, etc. 1 Boom RAISE MAX P Work equipment extended fully sec 3.1 – 3.9 Max. 4.9 2 Arm IN Boom top horizontal sec 3.6 – 4.4 Max. 4.7 E sec 3.8 – 4.6 Max. 4.9 L sec 7.0 – 8.6 Max. 9.0 3 Arm OUT P sec 2.7 – 3.3 Max. 3.5 2.8 – 3.4 Max.

3.5 4 Bucket CURL Boom top horizontal Arm cylinder retracted fully sec 2.4 – 3.0 Max. 3.3 5 Swing (5 turns) Work equipment extended fully Swing right and left sec 22.9 – 28.5 Max. 31 6 Travel (5 idle turns) One side of track pushed up and turned forward and backward LO LC sec 52.8 – 64.6 52.8 – 68.6 NLC MI LC sec 38.6 – 46.9 38.6 – 51.2 NLC HI LC sec 28.9 – 31.9 28.9 – 33.9 NLC