UEN00231-00 40 Troubleshooting Check before troubleshooting 1 4 PC210, 230, 240-8 Item Criterion Remedy Lubricating oil/Coolant 1. Check of level and type of fuel — Add fuel 2. Check of fuel for foreign matter — Clean and drain 3. Check of hydraulic oil level Between H – L Add oil 4. Check of hydraulic oil strainer — Clean and drain 5. Check of swing machinery oil level Between H – L Add oil 6. Check of level and type of engine oil (in oil pan) Between H – L Add oil 7. Check of coolant level (in sub tank) Between H – L Add coolant 8. Check of dust indicator for clogging No red part Clean or replace 9. Check of hydraulic oil filter — Replace Hydraulic/ Mechanical equipment 1.
Check for abnormal noise/smell — Repair 2. Check for oil leakage — Repair 3. Bleeding air — Bleed air Electric, electrical equipment 1. Check of battery terminals and wiring for loose- ness and corrosion — Retighten or replace 2. Check of alternator terminals and wiring for looseness and corrosion — Retighten or replace 3. Check of starting motor terminals and wiring for looseness and corrosion — Retighten or replace 4. Check of battery voltage (with engine stopped) 20 – 30 V Charge or replace 5. Check of electrolyte level Between H – L Add or replace 6. Check of wires for discoloration, burn, and removal of cover — Repair or replace 7.
Check for released wire clamp and drooping wire — Repair 8. Check of wires for wetness (Check connectors and terminals for wetness, in particular) — Dry 9. Check of fuse for disconnection and corrosion — Replace 10. Check of alternator voltage (while engine speed is at middle or higher) After operating for several minutes: 27.5 – 29.5 V Replace 11. Check of battery relay for operating sound (when starting switch is turned ON or OFF) — Replace