UEN00240-00 40 Troubleshooting Troubles that occur when power supply of pump controller is defective a The controller power supply (F01-17) of the pump controller drives the controller system. Accordingly, if it is turned off, the controller cannot control the system and the troubles shown below occur simulta- neously (The following is an example of the troubles). q The working mode cannot be changed. q The auto-decelerator does not work or is not reset. q The travel speed does not change. q The power maximizing function does not work. q The swing holding brake cannot be reset automatically. q The machine deviates during travel.
a If the above problems occur, check the related fuse (F01-17) and "green LED" of the pump controller to see if the power is supplied normally. q Lighting: The controller power is supplied (There is not an error and the power supply is normal). q Flashing: The controller power is supplied (There is an error). q Put out: The controller power is not supplied. a Green LED of pump controller (a) 10 PC210, 230, 240-8