Komatsu PC210-8, PC210LC-8, PC210NLC-8, PC230NHD-8, PC240LC-8, PC240NLC-8 — Information in troubleshooting table

UEN00240-00 40 Troubleshooting Information in troubleshooting table 1 a The following information is summarized in the troubleshooting table and the related electrical circuit diagram. Before carrying out troubleshooting, understand that information fully.

12 PC210, 230, 240-8 User code Failure code Trouble Trouble name displayed in abnormality record machine monitor Display on machine moni- tor Display on machine monitor Contents of trouble Contents of trouble detected by machine monitor or controller Action of machine moni- tor or controller Action taken by machine monitor or controller to protect system or devices when engine con- troller detects trouble Problem that appears on machine Problem that appears on machine as result of action taken by machine monitor or controller (shown above) Related infor- mation Information related to detected trouble or troubleshooting Possible causes and standard value in normal state Cause Standard value in normal state/Remarks on troubleshooting 1 Possible causes of trouble (Given numbers are refer- ence numbers, which do not indicate priority) • Standard value in normal state to judge possible causes • Remarks on judgment • Disconnection Connector is connected imperfectly or wiring harness is bro- ken.

• Ground fault Wiring harness which is not connected to chassis ground circuit is in contact with chassis ground circuit. • Hot short Wiring harness which is not connected to power source (24 V) circuit is in contact with power source (24 V) circuit. • Short circuit Independent wiring harnesses are in contact with each other abnormally. (1) Method of indicating connector No. and handling of T- adapter Insert or connect T-adapter as explained below for trouble- shooting, unless otherwise specified. • If connector No. has no marks of "male" and "female", disconnect connector and insert T-adapters in both male side and female side. • If connector No.

has marks of "male" and "female", dis- connect connector and connect T-adapter to only male side or female side. (2) Entry order of pin Nos. and handling of tester leads Connect positive (+) lead and negative (–) lead of tester as explained below for troubleshooting, unless otherwise specified. • Connect positive (+) lead to pin No. or wiring harness entered on front side. • Connect negative (–) lead to pin No. or harness entered on rear side. 2 3 4