Komatsu PC210-8, PC210LC-8, PC210NLC-8, PC230NHD-8, PC240LC-8, PC240NLC-8 — Failure code [CA123] Chg Air Press Sensor Low Error

UEN00240-00 40 Troubleshooting Failure code [CA123] Chg Air Press Sensor Low Error 1 24 PC210, 230, 240-8 User code Failure code Trouble Charge air pressure sensor low error (Engine controller system) E11 CA123 Contents of trouble • Pressure signal circuit of boost pressure/temperature sensor detected low voltage. Action of controller • Fixes charge pressure value and continues operation. Problem that appears on machine • Engine output lowers. Related infor- mation • Signal voltage on boost pressure side of boost pressure/temperature sensor can be checked with monitoring function. (Code: 36501 Boost pressure sensor voltage) • Method of reproducing failure code: Turn starting switch ON.

Possible causes and standard value in normal state Cause Standard value in normal state/Remarks on troubleshooting 1 Defective sensor power sup- ply 2 system If failure code [CA187] is also indicated, carry out troubleshooting for it first. 2 Defective boost pressure/ temperature sensor [pres- sure signal system] a Prepare with starting switch OFF, then turn starting switch ON and carry out troubleshooting. BOOST PRESS & IMT Voltage Between (3) – (1) Power supply 4.75 – 5.25 V Voltage is measured with wiring harness connected. Accordingly, if voltage is abnormal, check wiring harness and controller, too, for another cause of trouble, and then judge.

3 Ground fault in wiring har- ness (Short circuit with GND circuit) a Prepare with starting switch OFF, then carry out troubleshooting without turning starting switch ON. Wiring harness between CE01 (female) (44) – BOOST PRESS & IMT (female) (4) Resis- tance Min. 100 kz 4 Short circuit in wiring har- ness (with another wiring harness) a Prepare with starting switch OFF, then carry out troubleshooting without turning starting switch ON. Wiring harness between CE01 (female) (44) – BOOST PRESS & IMT (female) (4) and between CE01 (female) (47) – JC02 – BOOST PRESS & IMT (female) (1) Resis- tance Min.

100 kz 5 Defective wiring harness connector Connecting parts between boost pressure/temperature sensor – engine wiring harness – engine controller may be defective. Check them directly. • Looseness of connector, breakage of lock, or breakage of seal • Corrosion, bend, breakage, push-in, or expansion of pin • Moisture or dirt in connector or defective insulation 6 Defective engine controller a Prepare with starting switch OFF, then turn starting switch ON and carry out troubleshooting. CE01 Voltage Between (37) – (47) Power supply 4.75 – 5.25 V