UEN00240-00 40 Troubleshooting Failure code [CA153] Chg Air Temp Sensor High Error 1 34 PC210, 230, 240-8 User code Failure code Trouble Charge air temperature sensor high error (Engine controller system) E15 CA153 Contents of trouble • Temperature signal circuit of boost pressure/temperature sensor detected high voltage. Action of controller • Fixes charge temperature value and continues operation. Problem that appears on machine • Exhaust gas becomes white. • Engine protection function based on boost temperature does not work Related infor- mation • Signal voltage on boost temperature side of boost pressure/temperature sensor can be checked with monitoring function. (Code:
18501 Boost temperature sensor voltage) • Method of reproducing failure code: Turn starting switch ON. Possible causes and standard value in normal state Cause Standard value in normal state/Remarks on troubleshooting 1 Defective boost pressure/ temperature sensor [temper- ature signal system] a Prepare with starting switch OFF, then carry out troubleshooting without turning starting switch ON. BOOST PRESS & IMT (male) Resistance Between (2) – (1) 0.18 – 160 kz 2 Disconnection in wiring har- ness (Disconnection in wiring or defective contact in con- nector) a Prepare with starting switch OFF, then carry out troubleshooting without turning starting switch ON.
Wiring harness between CE01 (female) (23) – BOOST PRESS & IMT (female) (2) Resis- tance Max. 10 z Wiring harness between CE01 (female) (47) – JC02 – BOOST PRESS & IMT (female) (1) Resis- tance Max. 10 z 3 Short circuit in wiring har- ness (with another wiring harness) a Prepare with starting switch OFF, then carry out troubleshooting without turning starting switch ON. Wiring harness between CE01 (female) (23) – each of CE01 (female) pins (With all wiring harness connectors disconnected) Resis- tance Min. 100 kz 4 Defective wiring harness connector Connecting parts between boost pressure/temperature sensor – engine wiring harness – engine controller may be defective. Check them directly.
• Looseness of connector, breakage of lock, or breakage of seal • Corrosion, bend, breakage, push-in, or expansion of pin • Moisture or dirt in connector or defective insulation 5 Defective engine controller a Prepare with starting switch OFF, then carry out troubleshooting without turning starting switch ON. CE01 (female) Resistance Between (23) – (47) 0.18 – 160 kz