UEN00241-00 40 Troubleshooting Failure code [CA449] Rail Press Very High Error 1 20 PC210, 230, 240-8 User code Failure code Trouble Common rail pressure very high error (Engine controller system) E11 CA449 Contents of trouble • There is high pressure error in common rail circuit. Action of controller • Limits output and continues operation. Problem that appears on machine • Engine sound becomes large when no or light load is applied. • Engine output lowers. Related infor- mation • Common rail pressure can be checked with monitoring function. (Code: 36400 Common rail pressure) • Method of reproducing failure code: Start engine.
Possible causes and standard value in normal state Cause Standard value in normal state/Remarks on troubleshooting 1 Defect in related system If another failure code is displayed, carry out troubleshooting for it. 2 Air in low pressure circuit There may be air in low pressure circuit. Check it directly according to the following procedure. 1) Remove pressure pickup plug (outlet side) of fuel main filter. 2) Operate feed pump of fuel pre-filter. 3) Check pressure pickup plug for leakage of fuel and air. 3 Defect in fuel return circuit parts a For check of fuel return circuit pressure, see Testing and adjust- ing, Checking fuel pressure.
Fuel return circuit pressure Low idle running or cranking Max. 0.02 MPa {Max. 0.19 kg/cm2} 4 Defective common rail pres- sure sensor a Prepare with starting switch ON, then keep starting switch ON and carry out troubleshooting in each case. Monitoring code (Machine monitor) Monitoring information 36400 Common rail pressure While engine is stopped 0 ± 0.39 MPa {0 ± 4 kg/cm2} 5 Defective pressure limiter a For check of leakage through pressure limiter, see Testing and adjusting, Checking fuel return rate and leakage. Leakage through pressure limiter During low idle 0 cc (No leakage) 6 Defective supply pump If causes 1 – 5 are not detected, supply pump may be defective.