Komatsu PC210-8, PC210LC-8, PC210NLC-8, PC230NHD-8, PC240LC-8, PC240NLC-8 — Failure code [CA731] Eng Bkup Speed Sens Phase Error

UEN00241-00 40 Troubleshooting Failure code [CA731] Eng Bkup Speed Sens Phase Error 1 30 PC210, 230, 240-8 User code Failure code Trouble Engine Bkup speed sensor phase error (Engine controller system) E15 CA731 Contents of trouble • Phase error was detected in signals from engine Ne speed sensor and engine Bkup speed sensor Action of controller • Continues control with signal from engine Ne speed sensor. Problem that appears on machine • Engine does not start at all or does not start easily. • Idle speed is unstable. • Exhaust gas becomes black. Related infor- mation • Method of reproducing failure code: Start engine.

Possible causes and standard value in normal state Cause Standard value in normal state/Remarks on troubleshooting 1 Breakage of engine Ne speed sensor Engine Ne speed sensor may be broken. Check it directly. 2 Breakage of engine Bkup speed sensor Engine Bkup speed sensor may be broken. Check it directly. 3 Defective installation or breakage of rotation sensor wheel on crankshaft side Rotation sensor wheel on crankshaft side may be installed defec- tively or broken. Check it according to the following procedure. 1) Set No. 1 cylinder at compression top dead center (Match stamped mark).

2) If center of oblong hole of rotation sensor wheel is at tip of Ne speed sensor, rotation sensor wheel is installed normally. 4 Defective installation or breakage of rotation sensor ring on camshaft side Rotation sensor ring on camshaft side may be installed defectively or broken. Check it according to the following procedure. 1) Set No. 1 cylinder at compression top dead center (Match stamped mark). 2) Remove Bkup speed sensor. 3) If 2 grooves (1 crest) of rotation sensor ring are seen through sensor mounting hole, rotation sensor ring is installed normally. 5 Defective timing of crank- shaft and camshaft Timing of crankshaft and camshaft may be defective. Check it directly.

6 Defective connection of ground terminal Ground terminal may be connected defectively. Check following ter- minals directly. • Ground terminal of machine ((–) terminal of battery) • Ground terminal of engine • Ground terminal of engine controller • Ground terminal of starting motor