UEN00241-00 40 Troubleshooting Failure code [CA757] All Continuous Data Lost Error 1 32 PC210, 230, 240-8 User code Failure code Trouble All continuous data lost error (Engine controller system) E10 CA757 Contents of trouble • All data in engine controller are lost. Action of controller • None in particular. Problem that appears on machine • Engine may stop and may not be started again. • Monitoring function of machine monitor (engine controller system) may not work normally. Related infor- mation • Method of reproducing failure code: Turn starting switch ON.
Possible causes and standard value in normal state Cause Standard value in normal state/Remarks on troubleshooting 1 Defect in related system If another failure code is displayed, carry out troubleshooting for it. 2 Looseness or corrosion of battery terminal Battery terminal may be loosened or corroded. Check it directly. 3 Low battery voltage a Prepare with starting switch OFF, then keep starting switch OFF and start engine and carry out troubleshooting in each case. Battery (1 piece) Starting switch Voltage Between (+) – (–) terminals OFF Min. 12 V START Min. 6.2 V 4 Defective fuse No. 19 If fuse is broken, circuit probably has ground fault.
5 Defective relay for engine controller power supply a Prepare with starting switch OFF, then turn starting switch ON and carry out troubleshooting. Replace relay (R23, R24) for engine controller with another relay and perform reproducing operation. If "E" of failure code goes off at this time, replaced relay is defective. 6 Disconnection in wiring har- ness (Disconnection in wiring or defective contact in con- nector) a Prepare with starting switch OFF, then carry out troubleshooting without turning starting switch ON. Wiring harness between F01-19 – R23, R24 (female) (3) Resis- tance Max. 10 z Wiring harness between R23, R24 (female) (5) – CE03 (female) (3) Resis- tance Max.
10 z Wiring harness between CE03 (female) (1) – chassis ground (T12) Resis- tance Max. 10 z 7 Defective wiring harness connector Connecting parts between fuse No. 19 – machine wiring harness – engine controller may be defective. Check them directly. • Looseness of connector, breakage of lock, or breakage of seal • Corrosion, bend, breakage, push-in, or expansion of pin • Moisture or dirt in connector or defective insulation 8 Defective engine controller a Prepare with starting switch OFF, then turn starting switch ON and start engine and carry out troubleshooting in each case. CE03 (female) Starting switch Voltage Between (3) – (1) ON Min. 24 V START Min. 12 V