UEN00242-00 40 Troubleshooting Failure code [DW45KB] Swing Brake Sol Short 1 36 PC210, 230, 240-8 User code Failure code Trouble Swing holding brake solenoid system short (Pump controller system) E03 DW45KB Contents of trouble • When output to swing holding brake solenoid was turned ON, short circuit was detected in circuit. Action of controller • Turns output to swing holding brake solenoid OFF. • Even if cause of failure disappears, system does not reset itself until starting switch is turned OFF. Problem that appears on machine • Machine cannot swing (Swing holding brake is not reset).
Related infor- mation • If solenoid and wiring harness are normal, operator can swing machine by setting swing holding brake release switch in release position (Swing holding brake does not work, however, when machine stops). • Keep swing lock switch in OFF position and swing holding brake release switch in release position during troubleshooting. • Operating condition of swing holding brake solenoid can be checked with monitoring function. (Code: 02300: Solenoid 1) • Method of reproducing failure code: Start engine + Swing with left work equipment control lever.
Possible causes and standard value in normal state Cause Standard value in normal state/Remarks on troubleshooting 1 Defective swing holding brake solenoid (Internal short circuit or ground fault) a Prepare with starting switch OFF, then carry out troubleshooting without turning starting switch ON. V03 (male) Resistance Between (1) – (2) 20 – 60 z Between (1) – chassis ground Min. 1 Mz 2 Ground fault in wiring har- ness (Disconnection in wiring or defective contact in con- nector) a Prepare with starting switch OFF, then carry out troubleshooting without turning starting switch ON.
Wiring harness between C02 (female) (101) – D01 – J02 – S04 – V03 (female) (1), – S25 (female) (14) Resis- tance Min. 1 Mz 3 Defective pump controller a Prepare with starting switch OFF, then carry out troubleshooting without turning starting switch ON. C02 (female) Disconnect D01 and connect pins (3) and (7) on female side directly. Resistance Between (101) – (115), (117), (120) 20 – 60 z Between (101) – chassis ground Min. 1 Mz