UEN00243-00 40 Troubleshooting Failure code [DXE0KB] LS-EPC Sol Short 1 14 PC210, 230, 240-8 User code Failure code Trouble LS-EPC solenoid system short (Pump controller system) — DXE0KB Contents of trouble • When LS-EPC solenoid was driven, short circuit was detected in circuit. Action of controller • Turns output to LS-EPC solenoid OFF. • Even if cause of failure disappears, system does not reset itself until starting switch is turned OFF. Problem that appears on machine • Travel speed is high at Lo and Mi. • Work equipment speed and swing speed are high in lifting mode (L). Related infor- mation • Drive current of LS-EPC solenoid can be checked with monitoring function. (Code:
01500 LS-EPC solenoid current) • Method of reproducing failure code: Turn starting switch ON. Possible causes and standard value in normal state Cause Standard value in normal state/Remarks on troubleshooting 1 Defective LS-EPC solenoid (Internal short circuit or ground fault) a Prepare with starting switch OFF, then carry out troubleshooting without turning starting switch ON. V19 (male) Resistance Between (1) – (2) 7 – 14 z Between (1) – chassis ground Min. 1 Mz 2 Ground fault in wiring har- ness (Short circuit with GND circuit) a Prepare with starting switch OFF, then carry out troubleshooting without turning starting switch ON.
Wiring harness between C02 (female) (88) – V19 (female) (1) Resis- tance Min. 1 Mz 3 Defective pump controller a Prepare with starting switch OFF, then carry out troubleshooting without turning starting switch ON. C02 (female) Resistance Between (88) – (115), (117), (120) 7 – 14 z Between (88) – chassis ground Min. 1 Mz