Komatsu PC210-8, PC210LC-8, PC210NLC-8, PC230NHD-8, PC240LC-8, PC240NLC-8 — Failure code [DY2EKB] Wiper Drive (Rev) Short

UEN00243-00 40 Troubleshooting Failure code [DY2EKB] Wiper Drive (Rev) Short 1 38 PC210, 230, 240-8 User code Failure code Trouble Wiper motor drive reverse system short (Pump controller system) — DY2EKB Contents of trouble • When output to wiper motor drive reverse side was turned ON, short circuit was detected in circuit. Action of controller • Turns output to wiper motor drive reverse side OFF. • Even if cause of failure disappears, system does not reset itself until starting switch is turned OFF. Problem that appears on machine • Windshield wiper does not operate. Related infor- mation • Method of reproducing failure code: Turn starting switch ON + Set wiper switch to INT or ON.

Possible causes and standard value in normal state Cause Standard value in normal state/Remarks on troubleshooting 1 Defective wiper motor (Inter- nal short circuit or ground fault) a Prepare with starting switch OFF, then carry out troubleshooting without turning starting switch ON. M05 (female) Continuity/Resistance Between (1) – (3) There is continuity Between (1) – chassis ground Min. 1 Mz 3 Ground fault in wiring har- ness (Short circuit with GND circuit) a Prepare with starting switch OFF, then carry out troubleshooting without turning starting switch ON. Wiring harness between C02 (female) (114) – M05 (male) (1) Resis- tance Min.

1 Mz 4 Defective pump controller If causes 1 and 2 are not detected, pump controller may be defec- tive. (Since trouble is in system, troubleshooting cannot be carried out.)