Komatsu PC210-8, PC210LC-8, PC210NLC-8, PC230NHD-8, PC240LC-8, PC240NLC-8 — E-1 When starting switch turned ON, machine monitor displays nothing

UEN00244-00 40 Troubleshooting E-1 When starting switch turned ON, machine monitor displays nothing 1 6 PC210, 230, 240-8 Trouble • When starting switch turned ON, machine monitor displays nothing. Related infor- mation • When starting switch is turned ON, machine monitor displays KOMATSU logo, screen to input pass- word (if set), screen to check breaker mode (if set), screen of check before starting, screen to check working mode and travel speed, and ordinary screen in order. • When the engine is started, the battery voltage may lower suddenly, depending on the ambient tem- perature and the condition of the battery.

Possible causes and standard value in normal state Cause Standard value in normal state/Remarks on troubleshooting 1 Low charge level of battery a Prepare with starting switch OFF, then carry out troubleshooting without turning starting switch ON. Battery voltage (2 pieces) Electrolyte specific gravity (1 piece) Min. 24 V Min. 1.26 2 Defective fusible link F05 or fuse No. 20 If fusible link or fuse is broken, circuit probably has ground fault. (See Cause 5.) 3 Wrong connection of connec- tor Machine monitor connector may be connected wrongly. Check it directly.

(Check mounting bracket plate with connector.) 4 Disconnection in wiring har- ness (Disconnection in wiring or defective contact in con- nector) a Prepare with starting switch OFF, then carry out troubleshooting without turning starting switch ON. Wiring harness between battery (–) – chas- sis ground Resis- tance Max. 1 z Wiring harness between battery (+) – R04 – F05 (male) (1) Resis- tance Max. 1 z Wiring harness between F05 (male) (2) – F01-16D Resis- tance Max. 1 z Wiring harness between F01-17 – J06 – CM01 (female) (1), (2) Resis- tance Max. 1 z Wiring harness between CM01 (female) (3), (4) – chassis ground (T05) Resis- tance Max.

1 z Wiring harness between F01-17 – H15 (female) (1) Resis- tance Max. 1 z Wiring harness between H15 (female) (5) – J03 – CM01 (female) (14) Resis- tance Max. 1 z 5 Ground fault in wiring har- ness (Short circuit with GND circuit) a Prepare with starting switch OFF, then carry out troubleshooting without turning starting switch ON. Wiring harness between battery (+) – R04 – F05 (male) (1) Resis- tance Min. 1 Mz Wiring harness between F05 (male) (2) – F01-16D Resis- tance Min. 1 Mz Wiring harness between F01-17 – J06 – CM01 (female) (1), (2) Resis- tance Min. 1 Mz Wiring harness between F01-17 – H15 (female) (1) Resis- tance Min.

1 Mz Wiring harness between H15 (female) (5) – J03 – CM01 (female) (14) Resis- tance Min. 1 Mz 6 Defective machine monitor a Prepare with starting switch OFF, then hold starting switch OFF and ON and carry out troubleshooting in each case. CM01 Starting switch Voltage Between (1), (2) – (3), (4) OFF 20 – 30 V Between (14) – (3), (4) ON 20 – 30 V