UEN00244-00 40 Troubleshooting *1: Max. –3,430 Pa {Max. –350 mmH 2 O} *2: –7,470 ± 490 Pa {–762 ± 50 mmH 2 O} 22 PC210, 230, 240-8 Trouble (2) Fuel level monitor lights up red. Related infor- mation • Signal voltage of fuel sensor can be checked with monitoring function. (Code: 04200 Fuel sensor voltage) Possible causes and standard value in normal state Cause Standard value in normal state/Remarks on troubleshooting 1 Low fuel level (when system is normal) Fuel level may be low (below about 41 l). Check it and add fuel if necessary. 2 Defective fuel level gauge system If cause 1 is not detected, fuel level gauge system may be defective.
Carry out troubleshooting for E-11 Fuel level gauge does not indi- cate normally. Trouble (3) Air cleaner clogging monitor lights up red. Related infor- mation • Condition of signal of air cleaner clogging switch can be checked with monitoring function. (Code: 04501 Monitor input 2) Possible causes and standard value in normal state Cause Standard value in normal state/Remarks on troubleshooting 1 Clogging of air cleaner (when system is normal) Air cleaner may be clogged. Check it, then clean or replace if nec- essary. 2 Defective air cleaner clog- ging switch (Internal discon- nection) a Prepare with starting switch OFF, then start engine and carry out troubleshooting.
P23 (male) Air cleaner Resistance Between (1) – (2) When normal (Air intake resistance: *1) Max. 1 z When clogged (Air intake resistance: *2) Min. 1 Mz 3 Disconnection in wiring har- ness (Disconnection in wiring or defective contact in con- nector) a Prepare with starting switch OFF, then carry out troubleshooting without turning starting switch ON. Wiring harness between CM02 (female) (4) – P23 (female) (1) Resis- tance Max. 1 z Wiring harness between P23 (female) (2) – chassis ground (T09) Resis- tance Max. 1 z 4 Defective machine monitor a Prepare with starting switch OFF, then start engine and carry out troubleshooting.
CM02 Air cleaner Voltage Between (4) – chassis ground When normal (Air intake resistance: *1) Max. 1 V When clogged (Air intake resistance: *2) 20 – 30 V