Komatsu PC210-8, PC210LC-8, PC210NLC-8, PC230NHD-8, PC240LC-8, PC240NLC-8 — E-7 Precaution lights up while engine is running

UEN00244-00 40 Troubleshooting 24 PC210, 230, 240-8 Trouble (4) Engine coolant temperature monitor lights up white. Related infor- mation • Signals of engine coolant temperature sensor are input to engine controller and then transmitted to machine monitor through communication system. • Engine coolant temperature can be checked with monitoring function. (Code: 04107 Engine coolant temperature) Possible causes and standard value in normal state Cause Standard value in normal state/Remarks on troubleshooting 1 Insufficient warm-up of machine (when system is normal) If monitor lights up white, engine coolant temperature may be low (below about 30°C). Warm up engine. • Lighting up white:

Engine coolant temperature is low. • Lighting up blue: Engine coolant temperature is proper. 2 Defective engine coolant temperature gauge system If cause 1 is not detected, engine coolant temperature gauge sys- tem may be defective. Carry out troubleshooting for E-9 Engine coolant temperature gauge does not indicate normally. Trouble (5) Water separator monitor lights up red. Related infor- mation • Condition of signal of water-in-fuel sensor switch can be checked with monitoring function. (Code:

18800 WIF sensor condition) Possible causes and standard value in normal state Cause Standard value in normal state/Remarks on troubleshooting 1 Water separator is full (when system is normal) Water separator may be full of water. Check it, then drain if full. 2 Defective water-in-fuel sen- sor system If cause 1 is not detected, water-in-fuel sensor system may be defective. Carry out troubleshooting for failure codes [CA428] and [CA429]. Trouble (6) Hydraulic oil temperature monitor lights up white. Related infor- mation • Signals of hydraulic oil temperature sensor are input to pump controller and then transmitted to machine monitor through communication system.

• Hydraulic oil temperature can be checked with monitoring function. (Code: 04401 Hydraulic oil temperature) Possible causes and standard value in normal state Cause Standard value in normal state/Remarks on troubleshooting 1 Insufficient warm-up of machine (when system is normal) If monitor lights up white, hydraulic oil temperature may be low (below about 20°C). Warm up engine. • Lighting up white: Hydraulic oil temperature is low. • Lighting up blue: Hydraulic oil temperature is proper. 2 Defective hydraulic oil tem- perature gauge system If cause 1 is not detected, hydraulic oil temperature gauge system may be defective.

Carry out troubleshooting for E-10 Hydraulic oil temperature gauge does not indicate normally.