UEN00244-00 40 Troubleshooting E-21 Swing holding brake does not operate normally 1 40 PC210, 230, 240-8 Trouble (1) When swing lock switch is operated, swing lock monitor does not light up or go off. Related infor- mation • Condition of swing lock switch signal can be checked with monitoring function. (Machine monitor system code: 04502 Monitor input 3) (Pump controller system code: 02200 Switch input 1) Possible causes and standard value in normal state Cause Standard value in normal state/Remarks on troubleshooting 1 Defective swing lock switch (Internal disconnection or short circuit) a Prepare with starting switch OFF, then carry out troubleshooting without turning starting switch ON.
S04 (male) Swing lock switch Resistance Between (5) – (6) OFF Min. 1 Mz ON Max. 1 z 2 Disconnection in wiring har- ness (Disconnection in wiring or defective contact in con- nector) a Prepare with starting switch OFF, then carry out troubleshooting without turning starting switch ON. Wiring harness between CM02 (female) (5) – J02 – S04 (female) (5) Resis- tance Max. 1 z Wiring harness between S04 (female) (6) – J05 – chassis ground (T07) Resis- tance Max. 1 z 3 Ground fault in wiring har- ness (Short circuit with GND circuit) a Prepare with starting switch OFF, then carry out troubleshooting without turning starting switch ON.
Wiring harness between CM02 (female) (5) – J02 – S04 (female) (5), – C01 (female) (19) Resis- tance Min. 1 Mz 4 Defective machine monitor a Prepare with starting switch OFF, then turn starting switch ON and carry out troubleshooting. CM02 Swing lock switch Voltage Between (5) – chassis ground OFF 20 – 30 V ON Max. 1 V Trouble (2) When swing lock switch is turned ON, swing lock does not operate.
(Hydraulic drift of swing occurs on slope.) Related infor- mation Possible causes and standard value in normal state Cause Standard value in normal state/Remarks on troubleshooting 1 Defective swing lock switch (Internal short circuit) a Prepare with starting switch OFF, then carry out troubleshooting without turning starting switch ON. S04 (male) Swing lock switch Resistance Between (3) – (4) OFF Min. 1 Mz ON Max. 1 z 2 Defective swing holding brake release switch (Inter- nal short circuit) a Prepare with starting switch OFF, then carry out troubleshooting without turning starting switch ON. S25 (male) Swing holding brake release switch Resistance Between (13) – (14) Lock Min.
1 Mz Release Max. 1 z 3 Hot short (Short circuit with 24V circuit) in wiring harness a Prepare with starting switch OFF, then turn starting switch ON and carry out troubleshooting. Wiring harness between D01 (female) (3) – J02 – S04 (female) (3), – S25 (female) (14) Voltage Max. 1 V Wiring harness between S04 (female) (4) – V03 (female) (1), – D03 (female) (3) Voltage Max. 1 V