Komatsu PC210-8, PC210LC-8, PC210NLC-8, PC230NHD-8, PC240LC-8, PC240NLC-8 — H-6 Fine control performance or response is low

40 Troubleshooting UEN00245-00 H-5 Auto-decelerator does not operate 1 H-6 Fine control performance or response is low 1 PC210, 230, 240-8 11 Trouble • Auto-decelerator does not operate. Related information • Carry out this troubleshooting if auto-decelerator does not operate when travel lever is operated. Shuttle valve (in PPC valve) is installed between PPC valve and oil pressure switch of only in travel circuit. • Carry out all troubleshooting in power mode (P) of working mode.

Possible causes and standard value in normal state Cause Standard value in normal state/Remarks on troubleshooting 1 Malfunction of travel PPC valve (shuttle valve) a Prepare with engine stopped, then run engine at high idle and carry out troubleshooting. Travel lever PPC valve output pressure Neutral 0 MPa {0 kg/cm2} Forward Reverse 2.84 – 3.43 MPa {29 – 35 kg/cm2} Trouble • Fine control performance or response is low. Related information • Carry out all troubleshooting in power mode (P) of working mode.

Possible causes and standard value in normal state Cause Standard value in normal state/Remarks on troubleshooting 1 Malfunction of LS-EPC valve a Prepare with engine stopped, then run engine at high idle and carry out troubleshooting. Travel speed Travel lever LS-EPC valve output pressure Lo Neutral Approx. 2.9 MPa {Approx. 30 kg/cm2} Hi Operated 0 MPa {0 kg/cm2} 2 Clogging of LS circuit orifice Orifice of LS circuit (between pump – piping – control valve) may be clogged. Check it directly. 3 Defective adjustment or malfunction of LS valve a Prepare with engine stopped, then run engine at high idle and carry out troubleshooting.

Measured oil pressure Operation of levers and oil pressure ratio All levers in neutral Travel with no load (Lever operated half- way) Pump discharge pressure Almost same pressure 1 PC valve output pressure Approx. 0.6 (Approx. 3/5) If oil pressure does not become normal after adjustment, LS valve may have malfunction or internal defect. Check LS valve directly. 4 Malfunction of servo piston Servo piston may have malfunction. Check it directly.