Komatsu PC210-8, PC210LC-8, PC210NLC-8, PC230NHD-8, PC240LC-8, PC240NLC-8 — S-4 Engine stops during operations

40 Troubleshooting UEN00246-00 S-4 Engine stops during operations 1 *1:

Displayed failure codes [CA559] and [CA2249] PC210, 230, 240-8 11 General causes why engine stops during operations q Seized parts inside engine q Insufficient supply of fuel q There is overheating q Problem in drive devices on applicable machine side o Carry out troubleshooting for devices on applicable machine Causes Broken dynamic valve system (valve, rocker arm, etc.) Broken, seized piston, connecting rod Broken, seized crankshaft bearing Broken, seized gear train Insufficient fuel in tank Clogged air breather hole of fuel tank cap Leaking, clogged fuel piping Clogged fuel filter Broken, seized feed pump Broken supply pump shaft Stuck, seized supply pump plunger Broken auxiliary equipment (pump, compressor, etc.) Problem in drive devices on applicable machine side Questions Check items Confirm recent repair history Degree of use of machine Operated for long period E Condition when engine stopped Abnormal noise was heard and engine stopped suddenly w w w w Q w Q w w Engine overheated and stopped w Q Q Engine stopped slowly w Q There was hunting and engine stopped w Q Q Q Non-specified fuel is being used Q Q Q Replacement of filters has not been carried out according to Operation and Maintenance Manual w Fuel level monitor indicates low level (if monitor is installed) w When fuel tank is inspected, it is found to be empty w Air breather hole of fuel tank cap is clogged w Fuel is leaking from fuel piping w When priming pump is operated, it makes no reaction or it is heavy w Q Rust and water are found when fuel tank is drained w Metal particles are found when oil is drained w w w Q When engine is cranked by hand Does not turn at all w w Turns in opposite direction w Moves by amount of gear backlash w w Supply pump shaft does not turn w Engine turns, but stops when load is applied to machine w Troubleshooting Inspect dynamic valve system directly q Carry out troubleshooting on applicable machine Inspect piston, connecting rod directly q Inspect crankshaft bearing directly q Inspect gear train directly q Inspect fuel filter, strainer directly q Inspect feed pump directly q Carry out troubleshooting according to "Rail Press (Very) Low Error (*1)" indicated by code q q Engine rotates when pump auxiliary equipment (pump, compressor, etc.) is removed q Remedy Replace Replace Replace Replace Add Clean Correct Clean Replace Replace Replace Replace —