Komatsu PC210-8, PC210LC-8, PC210NLC-8, PC230NHD-8, PC240LC-8, PC240NLC-8 — S-7 Exhaust smoke is black (incomplete combustion)

UEN00246-00 40 Troubleshooting S-7 Exhaust smoke is black (incomplete combustion) 1 *1: Displayed failure codes [CA559] and [CA2249] *2: Displayed failure codes [CA144] and [CA145] 14 PC210, 230, 240-8 General causes why exhaust smoke is black q Insufficient intake of air q Defective condition of fuel injection q Improper selection of fuel q There is overheating o See "S-14 Coolant temperature becomes too high (Overheating)".

q Controller is controlling in derate mode (limiting injection rate (output) because of an error in electrical system) Causes Clogged air cleaner element Seized turbocharger, interference of turbocharger Defective contact of valve and valve seat Improper valve clearance Leakage of air between turbocharger and cylinder head Crushed, clogged muffler Worn piston ring, cylinder liner Stuck, seized supply pump plunger Clogged, seized injector Abnormally worn injector Improper fuel injection timing Improper fuel injection pressure Defective coolant temperature sensor, wiring harness Questions Check items Confirm recent repair history Degree of use of machine Operated for long period E E E E Color of exhaust gas Suddenly became black w w Q Q Q Gradually became black w Q Q Blue under light load w Non-specified fuel is being used Q Q Oil must be added more frequently w Power was lost Suddenly w Q Q Q Gradually Q Q Q Q Dust indicator is red w Muffler is crushed w Air leaks between turbocharger and cylinder head, clamp is loosened w Engine is operated in low-temperature mode at normal temperature Q Q Q When exhaust manifold is touched immediately after starting engine, temperature of some cylinders is low Q w When engine is cranked, interference sound is generated around turbocharger w When engine is cranked, abnormal sound is generated around cylinder head w Pump relief speed is high (Fuel is injected excessively) Q Exhaust noise is abnormal Q w Q Engine does not pick up smoothly and combustion is irregular Q Q Q Q Q w Blow-by gas is excessive w If spill hose from injector is disconnected, abnormally much fuel spills w Troubleshooting Inspect air cleaner directly q When turbocharger is rotated by hand, it is found to be heavy q When compression pressure is measured, it is found to be low q q Inspect valve clearance directly q When muffler is removed, exhaust sound improves q Carry out troubleshooting according to "Rail Press (Very) Low Error (*1)" indicated by code q q When a cylinder is cut out for reduced cylinder mode operation, engine speed does not change q Carry out troubleshooting according to "Coolant Temp Sens High (Low) Error (*2)" indicated by code q Check with monitoring function q q Remedy Clean Replace Replace Adjust Correct Replace Replace Replace Replace Replace Replace Replace Replace