Komatsu PC210-8, PC210LC-8, PC210NLC-8, PC230NHD-8, PC240LC-8, PC240NLC-8 — S-13 Oil level rises (Entry of coolant/fuel)

UEN00246-00 40 Troubleshooting S-13 Oil level rises (Entry of coolant/fuel) 1 20 PC210, 230, 240-8 General causes why oil level rises q Coolant in oil (milky) q Fuel in oil (smells diluted diesel fuel) a If oil is in coolant, carry out troubleshooting for "S-11 Oil is in coolant" Causes Broken cylinder head, head gasket Broken injector O-ring Cracks inside cylinder block Holes caused by pitting Worn, damaged rear oil seal Broken oil cooler core, O-ring Defects in supply pump Defective seal of auxiliary equipment (pump, compressor) Questions Check items Confirm recent repair history Degree of use of machine Operated for long period E E E E Fuel must be added more frequently w w Coolant must be added more frequently Q Q There is oil in coolant Q Q Q Q w Oil smells of diesel fuel w w Oil is milky Q Q When engine is started, drops of water come from muffler Q When radiator cap is removed and engine is run at low idle, an abnormal number of bubbles appear, or coolant spurts back w Q Exhaust smoke is white Q Oil level in damper chamber of applicable machine is low w Oil level in hydraulic tank of applicable machine is low w Troubleshooting When compression pressure is measured, it is found to be low q Remove injector and inspect O-ring q Inspect cylinder block, liner directly q q Inspect rear oil seal directly q Pressure-tightness test of oil cooler shows there is leakage q Remove and inspect supply pump directly q Inspect seal of auxiliary equipment directly q Remedy Replace Correct Replace Replace Correct Replace Replace Replace