50 Disassembly and assembly UEN00659-00 Special tool list 1 a Tool part number 79 Q T- QQQ - QQQQ indicates an interchangeable part (locally produced) a Necessity : t . . . . . . Special tools which cannot be substituted and should be always installed (used) : q . . . . . . Special tools which are very useful if available. They can be substituted with com- mercially available tools. a Distinction of new and existing special tools. : N . . . . . . Tools with new part numbers. They are newly developed for this model. : R . . . . . . Tools with upgraded part numbers. They are remodeled from already available tools for other models. : Blank. . .
Tools already available for other models and usable without any modification. a Circle ( Q ) in sketch column: A circle mark means that a sketch of the special tool is presented in the sec- tion of Sketches for Special Tools.
PC210, 230, 240-8 7 Work item Sym- bol Part number Part name Necessity Q'ty N/R Sketch Work content Engine front seal A 1 795-799-6400 Seal puller t 1 N Installation of engine front seal Engine rear seal 2 795-799-6500 Seal puller t 1 N Installation of engine rear seal Cylinder head assem- bly, fuel injector assem- bly 3 795-799-6700 Primer t 1 N Removal of fuel injector 4 795-799-1131 Gear t 1 Positioning with 3RD and 4TH cylinder Top 5 795-799-8150 Remover q 1 N Removal of inlet connector Cylinder head assembly 6 790-331-1120 Wrench (Angle) q 1 Angle tightening of bolt 7 795-790-4510 Gauge q 1 N Judgment of cylinder head bolt length Engine and hydraulic pump assembly 8 796T-401-1110 Plate q 1 N Q Removal and installation of engine and hydraulic pump assembly 9 795-790-9300 Lifting tool q 1 N Hydraulic pump assem- bly, Engine and hydrau- lic pump assembly, Control valve assembly, Center swivel joint assembly 10 796-460-1210 Oil stopper q 1 Stopping oil 11 796-770-1320 Adaptor q 1 Swing motor and swing machinery assembly F 1 796T-426-1410 Push tool t 1 Q Press fit of main bearing (PC210/230-8) 790-201-2860 t 1 Press fit of main bearing (PC210/230-8) 2 796-426-1120 Push tool t 1 Press fit of sub bearing 3 796T-426-1130 Plate t 1 Q Press fit of oil seal 790-101-5421 Grip t 1 01010-81240 Bolt t 1 Final drive assembly J 1 796-427-1400 Wrench assembly t 1 N Removal and installation of nut • 796-427-1410 • Wrench 1 N • 796-427-1140 • Pin 3 • 01314-20612 • Screw 3