50 Disassembly and assembly UEN00660-00 13. Disconnect two tube clamps (10). [*1] Installation 14. Disconnect fuel return tube (11). [*2] 15. Disconnect bracket (12). 16. Disconnect fuel return hose (13). 17. Remove fuel block (14). [*3] 18. Remove bellows (15). 19. Disconnect tube (9). [*1] q Installation is done in the reverse order of removal. a Figure: Refer to Removal . [*1] q How to install high-pressure pipe (9) 1. Tighten the sleeve nuts by hand. (both sides) 2. Tighten the sleeve nuts in the order of firstly the pump side, then the common rail side. 3 Sleeve nut: 35 ± 3.5 Nm {3.57 ± 0.36 kgm} 3. Install two tube clamps (10). 3 Clamp mounting bolt: 24 ± 4 Nm {2.45 ± 0.41 kgm} 4.
Install bellows (8) and (15). a Set the slits of each bellows out and down. a The bellows are installed so that fuel will not spout over the hot parts of the engine and catch fire when it leaks for some rea- son. [*2] 20. Remove three nuts (A parts) and remove fuel injection pump assembly (16). [*4] 3 Fuel return tube (11) mounting bolt: 24 ± 4 Nm {2.45 ± 0.41 kgm} [*3] 3 Fuel block mounting bolt: 32 ± 4 Nm {3.26 ± 0.41 kgm} [*4] 3 Fuel supply pump mounting nut: 24 ± 4 Nm {2.45 ± 0.41 kgm} q Air bleeding Bleed air from the fuel injection system. a Refer to the Testing and adjustment chap- ter. a Fuel injection pump assembly (16) comes off in one piece with the gear.
No treat- ment (tooth thinning etc.) has been given to the gear teeth for aligning the 1st and 6th cylinder tops. PC210, 230, 240-8 3