50 Disassembly and assembly UEN00660-00 Installation [*6] q Installation is done in the reverse order of removal. 3 Fan mounting bolt: 43 ± 6 Nm {4.4 ± 0.6 kgm} [*7] a Refer to the Inspection and Adjustment of Air Compressor Belt Tension section in the Testing and adjusting chapter in this manual. [*8] [*1] 3 Air cleaner band: 8.8 – 10.8 Nm {0.9 – 1.1 kgm} [*2], [*5] a Use brand new article for MIKALOR clamp. a Align the hose to the original position (marking position). a Reference Inserted air hose length 3 Flange mounting bolt: 43 ± 6 Nm {4.4 ± 0.6 kgm} a Reference Inserted radiator hose length: 40 mm 3 Radiator hose clamp:
10.8 – 11.8 Nm {1.1 – 1.2 kgm} [*9] a The bolt length of the engine front side is shorter than that of rear side. a The engine mounting rubber size of the engine front side is smaller than that of rear side. q Aftercooler side: 60 mm q Engine side A : 80 mm q Turbocharger side: 65 mm a Set bridge (BR) under the clamp tightening bolt as the lap with band (BR) is Min. 5 mm. a Align the clamp to the original position. a Impact wrench is not applicable to use. 3 MIKALOR clamp: 16 – 17 Nm {1.6 – 1.7 kgm} a When the tightening torque force is less than 16 Nm {1.6 kgm}, tighten it until the hand gap is adhered (BDG size is 0). 3 Engine mounting bolt (4 points):
245 – 308.9 Nm {25 – 31.5 kgm} a The nut is not welded except at the engine ground point. Due to that reason firstly fix nut locking tool (plate) A8 with bolt (B) to strict nut (N) turn, then remove engine mounting bolt (82). [*3] a Align the hose to the original position (marking position). a Align the clamp to the original position. a Reference Inserted air hose length • 49mm 3 Radiator hose clamp: 10.8 – 11.8 Nm {1.1 – 1.2 kgm} [*4] 3 Tube clamp: 10.0 – 11.0 Nm {1.02 – 1.12 kgm} Refer to [*5] [*2]. PC210, 230, 240-8 45