OPERATION 3.4 ELECTRONIC MONITORING AND CONTROL SYSTEM ECS Menu Control with Key Switch (C) and Key Group (D). Display of INPUTS-OUTPUTS Example: Display of menu items in the group *ANALOG-INPUTS*, starting from menu level -2-, see Menu Control Chart IV. The following menu items shall be displayed: Hydraulic oil temperature X2 Pilot oil pressure. Proceed as follows: 1. Starting from display level -2- Inputs-Outputs *ANALOG- INPUTS*; see chart IV. 2. Press key (10), the starting menu item ”B15 Hydraulic oil tem- perature” with the input designation (EW1.1) in level 3 is dis- played, and for example 72°C (present oil temperature). 3.
For display of the X2 pilot oil pressure, press key (12) four times, the following display appears: B86 X2 - Pressure (EW13.4): 35 bar Pressure may vary depending on operating condition. 4. For returning to the basic display press ”RET” key (9) three times. NOTICE Some designations of electrical units and their sequence within the DIGITAL INPUTS group on chart IV may not com- ply with the ECS version installed in your machine. However, the method of scrolling through the menu levels and input / output groups applies to all versions of the ECS system. Refer to the menu control list on page 156 for the applying menu version of your machine.
All electrical units installed in your machine are listed up on the Table of Inputs and Out- puts. This table is attached to the electrical diagram. 145