Komatsu — 3.6.1 EMERGENCY ENGINE SHUTDOWN SWITCHES

OPERATION 3.6 MACHINERY HOUSE 3.6.1 EMERGENCY ENGINE SHUTDOWN SWITCHES Legend for illustration Z26302 (1) Pulling chains for emergency shut down from ground man (special equipment). When one of the chains (1) is being pulled down for emergency shut down of both engines, the Operator will be informed by the following message, displayed on the ECS screen:

- # Engine shut down has been actuated from ground man- (2) Emergency engine shutdown switch (S33A) at the radiator door (3) Emergency engine shutdown switch (S33B) at the engine room wall opposite the main control valves (4) Emergency engine shutdown switch (S33C) in pump compartment on center post (5) Emergency engine shutdown switch (S33D) on rear machinery house post opposite the counterweight (A) Push button of emergency shutdown switches (2, 3, 4 and 5) for stopping the engines In case of emergency push in the button (A) to stop both engines. Never stop the engines from a full load except in case of emergency.

If a hot engine is shut down without previous idling period of three to five minutes, the temperature in certain engine parts rising sharply after the cooling sys- tem ceases to function. The resulting thermal stress, especially in the turbochargers, may cause serious dam- age. NOTICE For releasing button (A) turn it to the right, the button returns to normal position. The engines can then be started in the normal way at the control panel in the operator's cab. The engines can not be started with button (A) in depressed posi- tion. When one of the Shutdown switches (2 - 5) is activated, the ECS display informs the Operator by a corresponding message.

Machinery house doors (6) Main entrance door (7) Access doors to front engine (8) Center floor door (9) Access door to rear engine and to the emergency escape ladder at the counterweight NOTICE Make sure that all machinery house doors are securely closed before starting the engines. 203 WARNING WARNING