Komatsu — 3.7.1 STANDARD COMPONENTS IN CAB BASE

OPERATION 3.7 ELECTRICAL EQUIPMENT IN CAB BASE 3.7.1 STANDARD COMPONENTS IN CAB BASE REMARK On shovels equipped with electrical pre-heating systems there are additional components in the cab base. Refer to page 223 for more information. The cab base may contain high tension electrical appli- ances. Access to the cab base for authorized service staff only. DO NOT touch cables and their terminals and connected components. Always contact authorized electricians hav- ing the permission to work on medium and high voltage systems. Legend for illustration Z 22768 (1) Entrance door (2) Light switch (3) Mounting location of main switch board "X2". See page 213 for more information.

(4) Programmable Logic Controller (PLC) of the ECS system. See page 219 for more information. (5) Electronic control module (ECM) of the pump control system RC4 (6) Wiring harness connector (7) Signal horn with compressor Electronic Pump Control Module (5) The data link adapter for connecting an electronic tool to the con- trol module (5) is located in the Operator’s cab on the Operator’s console. 211 WARNING WARNING