OPERATION 3.9 CHECKS BEFORE STARTING THE ENGINES Before starting the Engines, make sure that no one will be endangered when starting the Engines.
CHECK THE FOLLOWING ITEMS Legend for illustration Z25823 (power unit viewed from operator’s cab side) (1) Engine oil pan dipstick oil level gauge (2) Oil filler tube for engine oil pan (3) Oil level sight gauge for reserve tank of the front engine on RH side member (4) Oil level sight gauge for reserve tank of the rear engine on LH side member (5) Coolant expansion tank of front engine radiator (6) Coolant expansion tank of rear engine radiator (7) Coolant level sight gauge on front and rear coolant expansion tanks (8) Radiator pressure caps (9) Pressure relief button Walk-around Inspection Make a ”Walk-around” inspection of the Shovel. Refer to Mainte- nance Section 4.
for the daily inspection items. Check oil level in front and rear engine oil pans and in both reserve tanks Check oil level with Shovel standing on level ground. Check oil level in engine oil pan with the dipstick oil gauge (1). For accurate readings, the oil level should not be checked until the oil has set- tled into the oil pan after the engine has been shut down (about 5 minutes). REMARK The oil level in the engine oil pan can vary between the MIN and MAX marking on gauge (1) depending on the operating con- dition of the reserve system when the engine was stopped.
With sufficient oil in the reserve tank and with the reserve system in proper working order, there is no need to fill the engine oil pan even with the oil level at the MIN mark on gauge (1). If the oil level is below the MIN marking on the gauge, corrective action must be taken. Fill the reserve tank and check the reserve system. The function of each reserve system is monitored by an indicator light located on the "X2" switch board in the cab base. See section "SWITCH BOARD (X2) IN CAB BASE" for more information. 231 CAUTION CAUTION