Komatsu — 3.9 CHECKS BEFORE STARTING THE ENGINES

OPERATION 3.9 CHECKS BEFORE STARTING THE ENGINES Check oil level in front and rear engine oil pans and in both reserve tanks (continued) Check oil level in both reserve tanks on sight gauges (3 and 4), illustration Z25823. If the oil level is at the MIN marking add engine oil via the swing down service arm to the MAX marking on the sight gauge. Refer to section "CENTRAL REFILLING SYS- TEM" on page 284 for more information. REMARK Be sure to fill the corresponding reserve tank of front engine -1- or the reserve tank of rear engine -2- when the information message "Engine oil reserve tank 1 (or 2) empty" is being displayed on the ECS screen in the operator’s cab.

Check coolant level in both expansion tanks DO NOT remove the radiator pressure cap (8), illust. Z25823 from a hot engine. Wait until the temperature is below 50°C before removing the pressure cap (8). Failure to do so can result in personal injury from heated coolant spray or steam. Press button (9) to allow the pressure to escape, then turn the cap until it is free to be removed. The coolant level should be in the upper field of the sight gauges (7). If necessary add coolant via the swing down service arm to the MAX marking on the sight gauge. Refer to section "CENTRAL REFILLING SYSTEM" on page 284 for more information.

REMARK Refer to the Engine Manual for the correct coolant composi- tion and filling procedure. Fill Engine Fuel Tank Engine fuel is flammable and can cause a fire or an explo- sion. Do not fill the fuel tank or service the fuel system near an open flame, welding, burning cigar or cigarettes, etc. Fill the fuel tank at the end of the of the shift to prevent condensa- tion from forming. Fill the fuel tank via the swing down service arm. Refer to section "CENTRAL REFILLING SYSTEM" on page 284 for more information. Observe the fuel specifications in the engine operation and maintenance manual. 233 WARNING WARNING WARNING WARNING