Komatsu — 3.10.1 STARTING PROCEDURE

OPERATION 3.10 STARTING THE ENGINES After starting observe the following: The ECS System monitors the Shovel’s functions and provides information about the appropriate operational data. If a FAULT message is displayed on screen (3), illustration Z25824 the acoustic warning signal (2) will sound simultaneously for approximately 1 second. In such a case proceed according to the instructions of the ECS system on page 92. Warning buzzer (2) will sound continuously when the hydraulic oil level is too low. In this case, stop the engines, locate and correct the cause immediately. Fill up hydraulic oil to the correct level. 11.

After warming up of the engines, the speed can be increased by setting switch (4) to high idle speed position. NOTICE DO NOT idle the engines for excessively long periods. Long periods of idling, more than 10 minutes, can damage the engine because combustion chamber temperature drop so low the fuel will not burn completely. This will cause carbon to clog the injector spray holes and piston rings and can cause the valves to stick. REMARK If one engine fails to work during operation, the shovel can be operated with the second engine as an emergency measure, e.g. for moving the shovel out of a danger area.

Automatic engine shut down system (safety chain) The engine(s) will be stopped or shifted to low idle speed auto- matically if a serious trouble condition occurs. The high level alarm (11) will sound approximately 10 seconds before an auto- matic engine shutdown occurs and will continue to sound during the 10 second period. At the same time a blinking message *SHUTDOWN* will be displayed on the ECS screen. Use the time period to move the machine to a safe place and lower the attach- ment to the ground. Inform service about the shutdown condition. Never let the engines run with disconnected batteries. This may cause alternator damage. 245 CAUTION CAUTION