OPERATION 3.16 STOPPING THE ENGINES Never stop the engines from full load except in case of emer- gency. Before shutting down run the engines at idling speed for 3 to 5 minutes. This cooling down period prevents heat accumu- lation and thermal stress, especially in the turbochargers. For EMERGENCY SHUTDOWN of the Engine, use STRIKE BUTTON (10). Additional emergency shut-down switches are located on the power house. For more information See "MACHINERY HOUSE" on page 202. Stopping procedure, see illustration Z25824. 1. Park the Shovel at a safe place on level and solid ground. For more information See "PARKING THE SHOVEL" on page 269. 2.
Deposit the working attachment onto the ground, proceed as follows: A - Backhoe Attachment Lower the backhoe attachment fully extended onto the ground in a position as shown on the oil level plate. B - Bottom Dump Bucket Attachment Lower the bottom dump bucket attachment onto the ground in a position as shown on the oil level plate. The positions A or B are necessary to prevent unintentional movement of the working attachment when the pressure in the hydraulic system is relieved and for correct checking of the hydraulic oil level. 3. Move all controls into neutral position. 4. Set toggle switch (4) to low idle speed position. Let the engines idle for about five minutes without load. 5.
Turn switches (7 and 9) clockwise to stop position. After the engines have come to standstill, relieve the pressure in the hydraulic system. 271 CAUTION CAUTION CAUTION CAUTION