Komatsu — 3.17.2 SWING CIRCLE PINION LUBRICATION SYSTEM ”SLS”

OPERATION 3.17 OPERATION OF THE LUBRICATION SYSTEM SWING CIRCLE LUBRICATION SYSTEM ”SLS” Manual actuation Mode of the Lubrication System with Ser- vice Key The manual actuation in the Service mode is useful for testing the electrical and hydraulic functions of the lubrication system. The pause time is reduced to 30 seconds and the holding time to 15 seconds permitting rapid sequences of lubrication cycles. In the manual actuation mode all monitoring functions of the system are made inoperative and, because of the very short pause and holding times grease will not reach to all lubrica- tion points.

Carry out manual lubrication by using the service key REMARK The swing ring lubrication system works only during slewing of the superstructure. 1. Insert key into service switch (3) and set to operating position. 2. Actuate the rotary switch (2) of the swing ring gear lubrication system. The message # SERVICE appears on the display. Up to ten repeated actuation of the switch are possible. The lubri- cation cycles are counted and displayed in the cycle counter window. 3. After finishing the manual lubrication remove service key. The system returns to the normal timer settings.

ADJUSTMENTS OF THE SWING CIRCLE LUBRICATION SYS- TEM The following adjustments can be made in the service menu of the ECS system: Level 4: Service Menu / Settings - 4 - Settings * CONDITION INDICATION * - 4 - Settings (minutes) * PAUSE TIME : * - 4 - Settings * LUBE CYCLE COUNTER : * Refer to section "ELECTRONIC MONITORING AND CONTROL SYSTEM ECS" for description of adjustment procedure. 277 CAUTION CAUTION