OPERATION 3.18 TRANSFER PUMP FOR HYDRAULIC OIL B - Pumping the oil from the suction oil reservoir into the main oil reservoir (continued) 9. Check oil level in the main reservoir. Fill up with new hydraulic oil as necessary. 10. Start the engines/motors and run at low idle speed for venting the suction system and hydraulic pumps. DO NOT start the engines/motors with the suction oil reser- voir empty. C - Pumping the oil from the return oil collector pipe into the main reservoir, necessary when changing the oil and before servicing the main control valves or high pressure filters and for replacing the filter screen in the collector pipe (9), illustration (Z 22425A). 1. Open valve (2). 2.
Switch on transfer pump with switch (4). 3. Observe oil level sight gauge at the main oil reservoir. As soon as the oil level remains constant the return oil collector pipe is empty. Now switch off the transfer pump (5). 4. After completion of the maintenance job close valve (2), posi- tion ”C”. 5. Make sure the pump switch (4) is in ”OFF” position. DO NOT start the engines/motors during servicing. 283 CAUTION CAUTION CAUTION CAUTION