Komatsu — 4.9.2 TRAVEL GEARS, BRAKE HOUSINGS AND MOTOR ADAPTER HOUSINGS - CHECK OIL LEVELS

MAINTENANCE 4.9 EVERY 50 OPERATING HOURS OR WEEKLY 4.9.2 TRAVEL GEARS, BRAKE HOUSINGS AND MOTOR ADAPTER HOUSINGS - CHECK OIL LEVELS Legend for illustration Z 20454 Travel gears (1) Oil level gauge (2) Oil filler plug (3) Breather filters (4) Drain plug Brake housings (5) Oil level plugs (6) Oil filler plugs (7) Oil drain plugs Motor adapter housings (8) Oil level plugs (9) Breather filter and oil filler openings (10) Oil drain plugs (11) Mileage indicator (special equipment) (12) Oil drain plug of final drive housing, see page 363 for more information. Check travel gear oil level: Remove oil level gauge (1) and wipe it clean. Screw in the gauge and remove again.

Oil level should be at the upper mark of gauge (1). If necessary add oil through filler opening (2). Remove breather filter (3). Blow out with compressed air from inside to out- side and reinstall. Check brake housing oil level: Check oil level by removing oil level plugs (5). Oil level should be at lower edge of openings (5). Add oil through filler openings (6) if necessary and install plugs (5) and (6). Check motor adapter housing oil level: Check oil level by removing oil level plugs (8). Oil level should be at lower edge of openings (8). Remove breather filter (9) and, if necessary, add oil through the filler opening.

Blow out breather fil- ter (9) with compressed air from inside to outside and reinstall. Install level plugs (8). 361