Komatsu — 4.10.4 SIGNAL HORN COMPRESSOR - LUBRICATE

MAINTENANCE 4.10 EVERY 250 OPERATING HOURS OR MONTHLY 4.10.2 UNDERCARRIAGE PIN CONNECTIONS - LUBRICATE See illustration Z 10972 Lubricate the pin connections via grease fittings (1) at center sec- tion (16 fittings; front, rear and from inside). 4.10.3 DRIVE SHAFTS - LUBRICATE See illustration Z 22866 1. Remove drive shaft guard. 2. Lubricate both universal joints at grease fittings (2). 3. Lubricate slip joint at grease fitting bleeder valve (1) until grease escapes at the release holes of slip joint tube. NOTICE To prevent damage to power train components observe the following: Lubricating pressure must not exceed 15 bar. DO NOT press in lubricant with strong shocks.

Make sure mounting bolts are correctly tightened and joint cap screws secured with lock wire. 4. After lubrication install the drive shaft guards. 4.10.4 SIGNAL HORN COMPRESSOR - LUBRICATE See illustration Z 10689 The compressor (2) is located in the cab base. Fill several drops of thin oil into the lubricator (1). The oil must be free from resin and acid and must have the lowest solidifying-point possible (below - 40° C). NOTICE If the Excavator is equipped with a second signal horn there is also a second compressor which has to be lubricated in the same way as the first one. 377