MAINTENANCE 4.12 EVERY 1000 OPERATING HOURS OR EVERY 6 MONTH 4.12.1 HIGH STRENGTH BOLT CONNECTIONS - CHECK TORQUE LOAD REMARK Check high-strength bolt connections and securing elements for damage and looseness. If any damages, failures or wrong condition are found, corrective action must be taken. If the torque load is not stated otherwise refer to standard torque chart for torque data. Bolts inserted with Multi-Purpose Grease MPG, KP2K on thread and head. When selecting the tightening torque observe quality grade and bolt size. Hydraulic Access Ladder, illust.
Z 22613 (1) Access ladder (2) Hand rail (3) Self locking nut (M24) for LH bearing assembly (4) (4) LH bearing assembly (5) Self locking nut (M39) for RH bearing assembly (6) (6) RH bearing assembly (7) Ladder lifting cylinder (8) Pivot pin (9) Stop bar (10) Valve bank in machinery house Check condition and fastening of hinged ladder (1), bearing assemblies (4 and 6) and hydraulic cylinder (7). Make sure the self locking nuts (3 and 5) are correctly tightened and have not lost their clamping torque. Tightening Procedure for Self Locking Nuts (3 and 5): Screw on the nuts until they have contact with the ladder car- rier frame.
Then tighten the nuts further by turning them through an angle of 45° (1/8 turn). Clamping Torque of Self Locking Nut (3): New nut: 106 Nm Used nut: 12 Nm minimum Clamping Torque of Self Locking Nut (5): New nut: 200 Nm Used nut: 20 Nm minimum If the clamping torque of nuts (3 and 5) is less than the minimum required value, replace them with new self locking nuts. Lubricate both eyes of hydraulic cylinder (7). Make sure both pivot pins (8) are properly secured with cotter pins. Check hydraulic lines for leakage and damage. Replace as necessary. 407