Komatsu — 4.12.2 HYDRAULIC SYSTEM - FILTER SERVICE

MAINTENANCE 4.12 EVERY 1000 OPERATING HOURS OR EVERY 6 MONTH FILTER SERVICE Clean or replace high pressure filter elements, illust. (Z 21114): 1. Place working attachment on the ground and shut-off the engines. Relieve pressure in the hydraulic system according to the instructions on page 270. 2. Place a suitable container below the filter in order to collect out flowing oil. Remove drain plug (2). 3. Screw off filter case (1). 4. Remove element (5) and clean. Take care not to contaminate the "Clean" inside of the element when flushing. Blow out element with compressed air from inside to outside. REMARK Carefully inspect elements for damage.

Always install new elements if ruptures or other damages are found 5. Inspect O-rings (3, 6 and 9) and back-up ring (4), replace if necessary. Prior installation apply clean hydraulic oil to back-up and O- rings. Install drain plug (2) with washer. 6. Fill filter case half way up with clean hydraulic oil. 7. Installation sequence vice versa. Make sure the pressure spring (7) is correctly installed. 8. After short operating period check filter units for leakage. NOTICE In case filter element (5) is soiled by metal chips, examine hydraulic pump for damages. Install new element (5). Replace elements (5) after three cleanings or after every 5000 operating hours, whichever occurs first.

If after cleaning of the filter element, the fault message ”High Pressure Filter restricted” is displayed again, replace the filter element. After pump repairs all high pressure filter elements must be replaced 453