Komatsu — 4.12.2 HYDRAULIC SYSTEM - FILTER SERVICE

MAINTENANCE 4.12 EVERY 1000 OPERATING HOURS OR EVERY 6 MONTH FILTER SERVICE Clean or replace filter elements of the hydraulic pressure fil- ters located at the central control and filter panel (A) and at the filter panels (10.1 and 10.2) mounted on the PTO’s, illus- tration Z22873 NOTICE When a fault message -Pressure Filter restricted- is dis- played, stop work and clean or replace element of the corre- sponding pressure filter.

Legend for illustration Z22873 (A) Central control and filter panel (B) Valve bank (8.1) Pilot oil filter 1 (8.2) Pilot oil filter 2 (9) Pressure accumulator for pilot oil circuit (10.1) Control and filter panel mounted on front PTO for engine 1 circuits (10.2) Control and filter panel mounted on rear PTO for engine 2 circuits (11.1) Pressure oil filter for pump distributor gear PTO -1- lubricating oil. Filter restriction monitored by differential pressure switch B27-1 (11.2) Pressure oil filter for pump distributor gear PTO -2- lubricating oil. Filter restriction monitored by differential pressure switch B27-2.

(12.1) Pressure oil filter for fan drive motor of hydraulic oil cooler and PTO gear oil cooler engine 1. Filter restriction monitored by differential pressure switch B28-1. (12.2) Pressure oil filter for fan drive motor of hydraulic oil cooler and PTO gear oil cooler engine 2. Filter restriction monitored by differential pressure switch B28-2. (13.1) Pressure oil filter for fan drive hydraulic motor of coolant radiator for front engine -1-. Filter restriction monitored by differential pressure switch B21-1. (13.2) Pressure oil filter for fan drive hydraulic motor of coolant radiator for rear engine - -2-. Filter restriction monitored by differential pressure switch B21-2.

(Y6-1) Solenoid valve for hydraulic oil cooler fan speed control engine 1 (Y6-2) Solenoid valve for hydraulic oil cooler fan speed control engine 2 (Y14-1) Not used (Y14-2) Not used (Y53-1) Solenoid valve for PTO gear oil cooler pre-load pressure engine 1 (Y53-2) Solenoid valve for PTO gear oil cooler pre-load pressure engine 2 (1 - 8) Main hydraulic pumps REMARK The pressure filters (11.1 and 11.2) for PTO gear lubrication can not be cleaned. These elements must be replaced. 455