MAINTENANCE 4.14 EVERY 3000 OPERATING HOURS HOWEVER AT LEAST ONCE A YEAR BRAKE HOUSINGS - CHANGE OIL See illustration Z 20454 NOTICE The brakes must be released for draining the oil. 1. Place wedges at front and rear side of both crawlers. 2. Start the engine and lower the bucket onto the ground. 3. Have a second person for control in the operator’s cab. 4. Remove parts (5, 6 and 7) and drain the oil. 5. After the oil is completely drained install plugs (7). 6. Shut down the engines/motors. 7. Fill in fresh engine or hydraulic oil up to level openings (5). Install plugs (5 and 6).
DO NOT fill the brake housings with the engine/motor run- ning, otherwise the brake housings will be overfilled leading to overheating and severe damage to the brakes. 8. Change oil in all four brake housings. NOTICE Be sure to fill the brake housings and motor adapter hous- ings with engine oil or hydraulic oil as specified on page 309. MOTOR ADAPTER HOUSINGS - CHANGE OIL 1. Remove parts (8 to 10) and drain the oil completely. 2. Clean breather filters (9). 3. Install drain plugs (10) and fill-up engine or hydraulic oil to level openings (8). Install plugs (8 and 9). 501 CAUTION CAUTION