Yanmar — Yanmar BY Series Electronic Control System Installation Manual

Installation Step 8 - Install the Stern Drive Actuator. Location Choose a suitable location for the Shift Actuator, considering the following requirements: The actuator is NOT waterproof. Choose a DRY location. The actuator needs 12 volt power and connects to the CANBus. The cable to the Stern Drive Shift Bracket requires adequate clearance and no sharp bends. The actuator should be mounted where it can be accessed for manual operation. Mounting There are two ways to mount the actuator and hardware is supplied for both mountings. 1. Three bolts are supplied for rear mount applications (bolt heads behind the mounting panel). 2.

Three screws and washers are supplied for front mount applications. Connections Connect the 12 volt (3 pin) power connection of the Shift Actuator to the 50 Amp Engine Breaker using cable CE10420, cut to length. This power should be connected so it comes through the Battery Switch and has a proper fuse. See pages 13 and 14 for details. Fuse NMEA 2000 ® CANBus Connection 12 volt (3 pin) Power Connection CE10420 Actuator Power Cable Red (Positive 12 Volts) Black (Negative) White (not used) Electronic Control System: Single Engine Installation Manual for BY Series Engines with Unlimited Controls Page 22 © Yanmar 2008