Installation Step 10 - Check the Installation. Connection Checks 1. Ensure all connectors are plugged in and properly seated. 2. Verify that the digital display and the control head are connected to the NMEA 2000 ® network. 3. Make sure the CANBus “T” Connectors are not tied down too tightly, thus causing stress. 4. Check each end of the NMEA 2000 ® CANBus to ensure that a terminator has been properly installed. 5. Verify that the engine ignition panel is properly connected at the helm station. 6. Check Marine Gear for correct gear solenoid voltage rating. All BY Unlimited installations require 12 volt solenoid on the transmission. 12 Volts DC Check 1.
Turn the battery switch and the engine breaker on. 2. Test for 12 Volts DC at the starter. Key Switch Check 1. Turn the key switch to the “on” position, but do not start the engine. 2. The i5601E display comes on. Module Light/Data Checks 1. The i5601E display now shows data. 2. The Control lever should be in the neutral position; the green SEL light and yellow light should be on. Note: The green light will be blinking on a dual station system. i5601E Display Check Press the left-most key on the digital display. The data should be available. Shift & Throttle Range of Motion Familiarize yourself with the shift and throttle control and the key switch.
After Checking the Installation - Boat in Operation After Installation and Check out is complete and with the boat operating in open water: 1. Check Neutral Start Protect to assure that the boat cannot be started in gear. 2. Check that the “Emergency Stop Switch” switch shuts off the engine when the lanyard is removed. 3. With the engine running, go to Appendix C and check the status of the CANBus. The CANBus voltage should be higher than 11.5 volts. The bus load should be above 0, but below 15%. The error frames, per second, should be less than 5, with 0 being typical. Electronic Control System:
Single Engine Installation Manual for BY Series Engines with Unlimited Controls Page 42 © Yanmar 2008