Yanmar — Yanmar BY Series Electronic Control System Installation Manual

Operations NOTE: The flashing yellow N (Neutral) lamp can indicate status of either Split Range Throttle (SRT) or Shift Disconnect (SD). Please exercise caution when engaging/disengaging either of these modes! A steady-on Neutral lamp ALWAYS indicates engine is in NEUTRAL. Split Range Throttle (SRT): Flashing yellow N (Neutral) lamp - SRT is engaged. Provides greater throttle sensitivity: moving an engine’s control lever to “Full Forward” will only produce the maximum percentage of WOT (Wide Open Throttle selected at set-up - typical Throttle Limit is 25%) TO ENGAGE SRT: Move engine lever to Forward Idle position. Press N (Neutral) button. ( Yellow lamp flashes.) TO DISENGAGE SRT:

Move engine lever to Forward Idle or Reverse Idle. Press N (Neutral) button. The yellow N (Neutral) lamp will go out - SRT is disengaged. Shift Disconnect (SD): Flashing yellow N (Neutral) lamp indicates SD is engaged. Allows throttle without gear engagement for engine start/ warm-up. TO ENGAGE SD: Move engine lever to the “Neutral” position. Press the N (Neutral) button. ( Yellow lamp flashes.) To Disengage SD: Return engine’s lever to the “Neutral” position. Press N (Neutral) button. The yellow N (Neutral) lamp will go steady - SD is disengaged and the engine/ transmission will now respond to lever commands. Electronic Control System:

Single Engine Installation Manual for BY Series Engines with Unlimited Controls © Yanmar 2008 Page 53