Operations Optional Trolling Mode Note: The Trolling Mode must be calibrated before trolling will operate properly. See Appendix F. The Trolling mode option allows the boat operator to slow the forward and aft speed of the boat for fishing. Trolling mode is achieved by the ECU electronically adjusting pressure bypass valves in the gearbox, allowing the clutches to slip. When trolling is selected (by pressing the separate trolling switch) and the control lever is moved forward, the boat will start to move at the slowest speed. As the lever approaches 60% throttle, the boat will be close to its non-trolling idle speed.
Moving the lever further forward will cause the transmission to lock out trolling and advance the throttle. The factory set defaults will limit throttle to 40%. The trolling defaults -- as shown in Appendix D -- can be set to a variety of operating modes. Contact your dealer for details, or see technical manual. How to Enter Trolling Mode: 1. Move the Control Head lever to the Neutral position. 2. Start the engine if necessary. The system must see RPM in order to permit trolling mode to be entered. 3. Press the separate trolling switch. This places the system in trolling mode. 4.
When you move the Control Head lever in either the forward or reverse direction, the engine RPM will remain steady, but the boat should move in the selected direction. 5. To take the boat out of the trolling mode, return the Control Head lever to the “Neutral” position and press the Trolling Switch. Control Lever Range of Operation Trolling Switch ........................................................ Trolling Throttle 60% 40% 40% Throttle Full Lock-up Electronic Control System: Single Engine Installation Manual for BY Series Engines with Unlimited Controls © Yanmar 2008 Page 55